Ξ

News

Credibility ,
the lifeblood of enterprise!
Your Location: Home > News
News - Yaang

The installation of the pipe reducers

DataTime:[2017-4-25]

Pipe reducers, also known as reducing soft rubber joints, the main products can be used for metal pipe loose tube connection.

Pipe reducers mainly has good elasticity, large displacement, installation is convenient wait for a characteristic, the product can greatly reduce the vibration and noise of pipe system, can fundamentally solve all kinds of pipeline interface displacement, axial expansion and concentricity problems.

Reducing joint at the time of installation you will first need to pay attention to the following:

1、 Pipe reducers construction when installation, must let it in the natural state, not to artificially make products to produce artificial deformation during installation. So that you can avoid cause of early damage of the product and use effect. In a flexible rubber joint to prohibit overheating when installation displacement limit

2、 if you install the product design in the pump export proximal or corner part of the pipeline, and high pressure, high building dangling when using the product, the pipe must have a fixed support or fixed bracket, fixed supported and fixed bracket force must be greater than the axial force, otherwise the product should be installed pulled off limit device.

3、 Pipe reducers during installation, you must make a sphere at both ends to enhance circle (highlights just wire rope) all CARDS into the flange groove, prevent the pipeline pressure on the ball and the flange pulled off.

       4、 Pipe reducers with pipe flange connection, the bolt screw should be extended to pipe flange at one end, in order to prevent the thread will be compressed rubber joint arch part to squeeze inflation hurt or injured, must be symmetrical each side of the bolt pressure to tighten, make the tightness of all bolts are consistent, use conditions, in addition to increasing flat pad, spring washer should be added, to prevent the nut is loose.

              Source: Yaang Pipe Industry Co., Limited (www.yaang.com)

Tel No:+86-18267732328 / Email:[email protected]
Address:Longwan District, Wenzhou, Zhejiang Province, China.

Copyright Notice © www.yaang.com Yaang Pipe Industry Co., Limited All rights reserved.
Yaang Pipe Industry Co., Ltd. is an international supplier of piping solutions for flange, butt welding fittings, socket welding fittings and threaded fittings. Our products are widely used in different industrial fields, including oil and gas, chemical industry, petrochemical industry, power plant, pulp and paper industry, environmental and water conservancy engineering, engineering projects, etc.