Pipe Threads

• NPT: American Standard Pipe Taper Thread
• NPSC: American Standard Straight Coupling Pipe Thread
• NPTR: American Standard Taper Railing Pipe Thread
• NPSM: American Standard Straight Mechanical Pipe Thread
• NPSL: American Standard Straight Locknut Pipe Thread

The word “taper” mentioned above refers to the difference between many pipe threads and those on bolts and screws. Pipe threads not only a make mechanical joint but also a leak proof one. To do this, the threads become shallower the farther they are from the end of the fitting or the pipe. The bottoms of the threads taper. The taper is 1/16 inch in an inch.

Because of the taper, a pipe can only screw into a pipe fitting a little distance before it jams. The standard represents this distance, the effective thread. The standard also represents another distance, the engagement, which is the distance the pipe can be screwed in by hand, without much effort. For workers, it is more easy to know how many turns to make by hand or with a wrench. 


Types of pipe threads

Various threads available in pipe and pipe fittings are as follows: 

• Right-handed or Left-handed Threads
  Nearly all threads are oriented so that a bolt or nut or any fitting can be tightened. By turning it in a clockwise direction, the item turned moves away from the viewer. And it is loosened by turning anticlockwise when the item moves towards the viewer . This is known as a right-handed thread. Left-handed threads are oriented in the opposite direction. There are also self-tapping screw threads where no nut or bolt is required.
• Male Threads
  In male threads, the threads of the pipe are on the outside. Here, tapered pipe threads like NPT, BSPT etc. are used sealing without gaskets.
• Female Threads
  In female threads, the threads are on the inside. Here too, like male threads, tapered pipe threads are used for sealing.
• Male Straight Thread
  Pipe threads like UNC, UNF, ASME, etc form Male Straight Thread.
• Female Straight Thread
  Straight pipe threads like UNC, UNF, ASME, etc.
• Plain End
  This is used to connect or insert into the bell end of the connecting pipe.
• Bell / Socket / Flare
  This represents the end length of increased diameter into which a pipe end can be fitted.
• Flange
  Flanges are used to connect fitting, via bolting or welding. There are basically two types of flanges, circular and square.
• Compression Fitting
  This represents compression nut and ferrule to connect to a mating pipe.
• Pipe Clamp End
  It is so designed so as to attached to run on pipe or other fitting.
• Barb / Rib
  This represents fitting ends to connect only non-rigid pipe or hose. It is sometimes used with a clamped end.
• Groove
  This refers to the installation of a coupling feature like an o-ring or elastomeric seal.