Notice of installation reducer

DataTime:[2016-11-25]

When the reducer is installed, in the event the diameter of the internal pipe diameter and aperture size doesn't match, then you should be appropriate for the neck shrinkage or expansion. After installation, so as not to affect the distribution with the velocity field, pressure loss is ultimately caused, and the measurement accuracy in the electromagnetic flowmeter is necessary. Normally, the biggest market of the cone angle can be controlled at less than 15 degrees.

Notice of installation reducer

1. If the fluid flows in the pipe, the flow changes in a small range, whether it be increased or reduced, you should use the reducer.

2. When installing kit reducer, we should attempt to avoid cavitation with the pump inlet position.

Three. When installing a reducer in the inlet position with the pump, the gas needs to be guaranteed not to be condensed from the lower position.

4. If the inlet in the pump is changed, the concentric reducer ought to be selected. In the event the pipe all the way through in to the pump, you need to pick the top flat reducer if the order is from top to bottom, you need to find the bottom flat speed reducer instead.

5. Within the installation process, the flow meter needs to be selected according to the actual flow rate in the process pipe.

∧TOP

Next: What is the high temperature alloy?
Prev: List of Chemical Elements

Tel No：+86-18267732328 / Email:[email protected]
Address：Longwan District, Wenzhou, Zhejiang Province, China.

Copyright Notice © www.yaang.com Yaang Pipe Industry Co., Limited All rights reserved.
Yaang Pipe Industry Co., Ltd. is an international supplier of piping solutions for flange, butt welding fittings, socket welding fittings and threaded fittings. Our products are widely used in different industrial fields, including oil and gas, chemical industry, petrochemical industry, power plant, pulp and paper industry, environmental and water conservancy engineering, engineering projects, etc.