Surveying and mapping method for 180 degree stainless steel pipe fittings

DataTime:[2016-7-28]

180 degree stainless steel pipe fittings mapping method are as follows:

180 degree stainless steel pipe fitting mapping method

(1) with wire or the level of Surveying and mapping at both ends of the flange hole.
(2) with horizontal surveying and mapping at both ends of the 625 vertical surface of the flange, with the line or the right angle of the 625 sides of the drawing end of the two sides of the horizontal direction of the mouth:
(3) surveying and mapping 180 degrees stainless steel pipe fittings a, b,
The surveying and mapping method of horizontal stainless steel pipe fittings with arbitrary angle is shown in the drawing:
180 degree stainless steel pipe fitting mapping method

(1) by the pipe Ⅰ Ⅱ, each lead to angled line surveying and mapping a, b's length;
(2) the side draw with Angle ruler. A, b, the Angle of the intersection between 0;
(3) levels of surveying and mapping a worker, tube II, 625 vertical surface of the flange, surveying and mapping out the flange eyes at the same time,

(4) at the same time with computing or loft and blanking length.

Source: Yaang Pipe Industry Co., Limited (www.yaang.com)

∧TOP

Next: What is threaded flange?
Prev: List of Chemical Elements

Tel No：+86-18267732328 / Email:[email protected]
Address：Longwan District, Wenzhou, Zhejiang Province, China.

Copyright Notice © www.yaang.com Yaang Pipe Industry Co., Limited All rights reserved.
Yaang Pipe Industry Co., Ltd. is an international supplier of piping solutions for flange, butt welding fittings, socket welding fittings and threaded fittings. Our products are widely used in different industrial fields, including oil and gas, chemical industry, petrochemical industry, power plant, pulp and paper industry, environmental and water conservancy engineering, engineering projects, etc.